18
1.5.1 Manual Network Interface Configuration
This section describes how to manually configure the network interface.
Proceed as follows:
1.
Open the settings for the network adapter connected to UULA.
2.
In Windows 10, select
Network and Sharing Center
.
Depending on the Windows version, you may have to select
Network & Internet settings
.
3.
Select
Change adapter options
.
4.
Double click the network adapter that is connected to UULA.
5.
Select
Properties
.
6.
Select
Internet Protocol Version 4 (TCP/IPv4)
>
Properties
.
7.
Select
Use the following IP address
. Enter the details below:
Figure 16 Network Adapter Settings
8.
Select
OK
.
Reboot your computer if needed.
1.6 Installing Focalspec Map
This section describes how to install the Focalspec Map software. Proceed as follows:
1.
Copy setup.exe from the USB memory stick or download it from LMI support site to the C drive.
2.
If you have purchased FocalSpec Map and have a license dongle, insert it into the USB drive prior to installing.
3.
Extract the zip package and based on your operation system run either Setup32.exe in Install folder or Setup64.exe
in Install 64 folder.
4.
After starting the install below window opens
Содержание FocalSpec
