Livox HAP, Руководство пользователя

Страница: 12 / 23

LIVOX HAP User Manual
12
©
2022 Livox Tech All Rights Reserved.
0
10
20
30
40
-40 -35 -30 -25 -20 -15 -10 -5 0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85
功率
(W
)
温度 ( ℃ )
图表标题
启动功率 运行功率 运行功率
(
开启窗口加热模式
)
36W
22W
12W
Figure 4.1.1 The working power of the HAP (TX) at different temperatures
Power (W)
Temperature (° C)
Connection
The M12 aviation connector of HAP (TX) supports transmission of power and data. Refer to the
Connectors section for more information about the connector. It is recommended to use the
Livox Aviation Connector 1-to-3 Splitter Cable (sold separately) when testing or using the HAP
(TX) temporarily. The Livox Aviation Connector 1-to-3 Splitter Cable contains the M12 aviation
connector (male), power cable (bare wires), function cable (with insulation) and network cable (with
RJ-45 connector).
The HAP (TX) transfers data using the User Datagram Protocol (UDP). All HAP (TX) are set to
static IP address mode by default with an IP address of 192.168.1.100. The default subnet
masks of HAP (TX) are 255.255.255.0 and their default gateways are 192.168.1.1. Directly
connect the HAP (TX) to a computer.
1. Before connecting, set the IP address of the computer to static IP address mode. Set the IP
address of the computer to the same network subnet as the IP address of HAP (TX). Follow
the steps to set the IP address of your computer to static IP address:
Windows system
a. Click to enter the Network and Sharing Center under Control Panel.
b. Click the network you are using and click “Properties”.
c. Double click “Internet Protocol Version 4 (TCP/IPv4)”.
d. Set the static IP address of the computer to 192.168.1.XX (make sure the IP address is
different from the connected LiDAR sensor), such as 192.168.1.50 and that the subnet
mask is set at 255.255.255.0. Click “OK” to complete.
Startup Power Working Power Working Power (in window-heating mode)
Additionally, the HAP (TX) supports the window-heating mode, which can be used for defrosting
and defogging the window. Users can choose to turn on or off the window-heating mode based
on their needs. In window-heating mode, the working power may increase by 10 W. The working
power of the HAP (TX) varies at different temperatures. Make sure the power supply is suitable
based on the peak power of the HAP (TX). The value is for reference only. In normal conditions,
the peak power varies depending on each sensor.