24 pcs.
Ø5/16-18 × 1-1/2"
Long Allen-Head
Bolt
24 pcs.
J
Components packed with the Dining Table TOP
Made in Viet Nam
Page 1 of 2
C
aira
Rectangle
Dining Room
Assembly Instructions
21542 Double Pedestal Dining Table TOP
21543 Double Pedestal Dining Table BASE
Ø5/16" x 12 x 3mm
Spring Washer
Table Top
1 pc.
A
Table Top Leaf
1 pc.
B
Components and Hardware packed with the Dining Table BASE
Bridge Panel
2 pcs.
C
Pedestal
Column
Bottom Frame
2 pcs.
D
2 pcs.
E
Ø5/16-18 × 3-1/4"
Long Allen-Head
Bolt
16 pcs.
H
8 pcs.
I
F
Ø5/16" x 19 x 2mm
Flat Washer
Be sure to check all packing material carefully for small parts, which may have come loose inside the carton during shipment.
Separate, count and check all parts against the Components and Hardware List above. Failure to use the correct length bolts in
the proper locations may result in an unsafe product and could also cause damage to the parts being assembled.
5mm Allen Wrench
1 pc.
G
ASSEMBLY STEPS:
Note: To prevent possible damage and scratches, this table should be assembled on a clean, soft surface such as a
blanket or carpet.
1. Attach the two Bridge Panels (C) to the top end of the Pedestal Columns using the 1-1/2" Long Allen-Head Bolts (F),
Spring Washers (H) and Flat Washers (I). Tighten with the Allen Wrench (J).
2. Turn the assembled Columns and Bridge Panels upside down and attach the Bottom Frames (E) to the Columns
using the 3-1/4" Long Bolts (G), and the same Washers as previous Step. Tighten with the Allen Wrench.
21742 Double Pedestal Dining Table TOP
21743 Double Pedestal Dining Table BASE
J
F
H
I
C
J
G
H
I
D
E
STEP 1
STEP 2
