Living & Co HQ15-20M, Руководство пользователя

Страница: 9 / 15

• The heater is su itable for operation on an AC power supply having the same
voltage listed as on the rating label (220–240V~ 50Hz).
• Before you insert the plug into a su itable wall outlet, ensure the heater is intact,
properly ass embled and the cord is undamaged. To avoid overloading a circuit,
only plug the heater into a circuit that has no other appliances connected.
• With both cont rols set to the OFF and minimum positions, insert the plug into
an appropriately installed wall socket and switch on power to the outlet.
• The heater has four quartz heating elements, which can be operated on four
heat settings. It also featur es a thermostat, which can be set to cont rol the
temperature. Operation is explained in detail on the next page.
Instructions
Introduction
This Heater features specially designed internal structures with lar ge
aluminium conductive fins to distribute heat in two directions: radiant heat
through the heat outlet grille at the front, and strong natural convection heat
through the heat outlets at the top.
Positioning the heater
Place the heater in an upright position on a flat, stead y , stable, heat- resistant
surface. Make sure there ar e no flammable or heat sensitive materials or
substances within one met re of the heater. Operating the heater in any other
position could cause a hazard.
Connecting the heater
WARNING!
• Do not operate the heater without the castor wheel assemblies attached.
• Only operate the heater in an upright position (wheels on the bottom,
controls at the top), any other position could create a hazard.
FIRST USE
The heater may pr oduce fumes or odour when it is first heating up. This is
due to the components being new and can be dis regarded safely. It is entirely
harmless. When switching on the heater for the first time, allow it to run at full
power for about two hours until all odour and/or smoke has dissipated. Ensu
re
there is adequate ventilation.