6-CIA
Cast Iron Submersible Sump Pump
Basement sumps, dewatering, water transfer
•
1/3 HP shaded pole motor
•
Designed for continuous duty
•
Epoxy-coated cast iron housing
•
32 mm garden hose adapter available
•
Carbon/ceramic shaft seal
•
Upper and lower sintered sleeve bearings
•
IP 68
•
Height:152mm Length: 241mm Width: 215mm
Capacity:
156 LPH @31m
Shut Off:
4.1m
Discharge:
38mm
Electrical:
230V, 50/60Hz, 4.5A, 720W
MODEL:
506166
Introduction
This instruction sheet provides you with the information required to safely own and operate your product. Retain these
instructions for future reference.
The product you have purchased is of the highest quality workmanship and material, and has been engineered to give you
long and reliable service. This product has been carefully tested, inspected, and packaged to ensure safe delivery and
operation. Please examine your item(s) carefully to ensure that no damage occurred during shipment. If damage has
occurred, please contact the place of purchase. They will assist you in replacement or repair, if required.
READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL, OPERATE, OR SERVICE YOUR PRODUCT.
KNOW THE PRODUCT’S APPLICATION, LIMITATIONS, AND POTENTIAL HAZARDS. PROTECT YOURSELF AND OTHERS BY
OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN PERSONAL
INJURY AND/OR PROPERTY DAMAGE!
SAFETY GUIDELINES
WARNING:
Risk of electric shock. This pump is supplied with a grounding conduc- tor and/or grounding type attachment
plug. To reduce the risk of electric shock, be certain that it is connected to a properly grounded grounding type receptacle.
WARNING:
Always disconnect the electrical power before touching the pump or discharge when water is present in the
sump. Failure to do so can result in hazardous electrical shock.
WARNING:
To reduce the risk of electrical shock, pull plug before servicing this pump.
Read all instructions and Safety Guidelines thoroughly. Failure to follow the guide- lines and instructions could result in
serious bodily injury and/or property damage.
Check local electrical and building codes before installation. The installation must be in accordance with their regulations.
During normal operation the sump pump is immersed in water. Also, during rain storms, water may be present in the
surrounding area of the pump. Caution must be used to prevent bodily injury when working near the pump:
Electrical power should be disconnected prior to touching, servicing or repairing the pump.
To minimize possible fatal electrical shock hazard, extreme care should be used when changing fuses. Do not stand in
water while changing fuses or insert your finger into the fuse socket.
Do not run the pump in a dry sump. If the pump is run in a dry sump, the surface temperature of the pump will rise to a
high level. This high level could cause skin burns if the pump is touched and will cause serious damage to your pump.
Do not oil the motor. The pump housing is sealed. A high grade dielectric oil devoid of water has been put into the motor
housing at the factory. Use of other oil could cause serious electric shock and/or permanent damage to the pump.