Children's Furniture Made In America
Established 1987
www.littlecolorado.com
Lt_
WARNING: Adult Assembly Required
WARNING: Assembly Kit Contains Parts With Sharp Points, Sharp Edges,
and Small Parts That Can Present Choking Hazards to Children.
REVISED 06/17
D. DOMINGUEZ
WARNING: Components Are Packed In Plastic Bags That Are A Suffocation Hazard.
Assembly Instructions For Play Stand - Item# 12
Contents:
2 Wooden Ends
1 Wooden Shelf
1 Wooden Shelf Support
1 Wooden Rod
6 Joint Connector Bolts
6 Barrel Nuts
1 Allen Wrench
3 1-1/4 " Wood Screws
2
-
1
-
5/8" Wood Screws
You will need a standard
phillips screwdriver to
complete assembly.
.
I
I
I
I
I
I
�
--�-----------�--�-----
��
'
UY'
W�--- --
----------L.
..·._--:·)>···""'�
'
----
'
'O·-'-·"".
-{l
c:::=��
,.· :(--....
-{l
Recommended Age
Grade is 2 Years Old
1. Please inspect the parts for damage during shipping and for any missing items. If you suspect that there may be damage
or a shortage, call us and we will send replacement parts if needed. At this time, visualize how the components fit together
per the above drawing and make sure that you have everything identified.
2.
Insert two of the barrel nuts into the holes on underside of the right side of the shelf. Put the smooth side in first so that
the slotted side is showing and align the longest slot toward the bolt hole. You should be able to look into the smaller holes in
the ends of the part and see the threaded openings in the barrel nuts. If necessary, rotate the barrel nuts with a screwdriver
so that they line up perfectly.
3. Holding the shelf and a side upside down, insert the right side of the shelf into the slot and install two joint connector
bolts. Be sure the slot in the shelf is on the lower side. Using the allen wrench provided, tighten these two bolts until the
wrench first starts to become harder to turn. Then loosen the bolts by one full turn.
4. Insert the shelf support into the slot in the same side and into the slot under the shelf. Now install one bolt and barrel nut
following the same tightening and loosening procedure as in #3.
5. Now fit this shelf and support assembly into the other side and install three bolts following the same tightening and loos
ening procedure as in #3.
6. Slide the rod through the holes near the top so the the ends stick out exactly one inch from each side.
7. Place stand on a hard level surface and adjust it so that it sits evenly on all four corners.
8. Screw in the three 1- 1 /4" screws through the top of the shelf into the shelf support until tight.
9. Now tighten all six bolts until snug. Check the rod again to be sure there is exactly one inch sticking out of each side and
screw in the two 2" screws that angle in through the tops of the sides to secure it. You can now begin using the Play Stand.
All of us at Little Colorado, LLC hope that you and your little ones enjoy this Play Stand for many years. Please contact us if
you need any help in assembly. The greatest creative play value is gained by using two Play Stands together. A Play Stand
Canopy (item #14 ), Our Colorful Silks (item # 15) and Wooden Clips (item # 13) are wonderful accessories to consider.
Manufactured by Little Colorado, LLC 4450 Lipan Street Denver, CO 80211
Phone 303-964-3212 Fax 303-964-3213 www.littlecolorado.com email [email protected]
