Carnivale v1.1
Manufacturers and product names are mentioned solely for circuit identification, and where applicable their trademarks are the
property of their respective owners who are in no way associated or affiliated with the author. No cooperation or endorsement
is implied.
6
Off board wiring
As mentioned before, you can either mount the potentiometers directly to the PCB with special
potentiometers or use the traditional solder lug potentiometers.
Potentiometers non PCB mounted
In the pictures below you see the correct pin numbering of the pots.
Solder the wires accordingly and it is always a good idea to twist the wires together to create a sort
of extra shielding against external noise.
You can break of the pin I marked with the yellow circle with a small pair of pliers.
Potentiometers PCB mounted
I would advise that you first drill the 3 holes for the potentiometers in the enclosure. Now insert the
pots in the enclosure, tighten the bolts and then click the PCB on the pots from the bottom (non
component) side like this:
You can best solder the pots while in the enclosure. When you are done, you can measure where to
put the rest of the components (footswitch, DC jack, in-/output jacks, LED) and determine where to
drill the holes.
NB make sure the underside of the pots do not touch the PCB else there might be a short circuit. Use
special plastic Alpha caps or some tape to isolate the pots from the PCB.
3 2 1
1 2 3
3 2 1
P1 Drive
P2 Tone
P3 Volume
P1a Gain
1 2 3
Содержание Carnivale
Страница 1: ...Carnivale Building instructions v1 1...
