WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it’s subsidiaries are fully tested
prior to shipment and are warranted against defective materials and
workmanship for a period of five full years from the date of the
original shipment. Should a problem occur, a Return Material
Authorization Number (RMA) must be obtained from Liteway Inc. at
(516) 931-2800 and the item returned to Liteway, Inc. 166 Haverford
Road, Hicksville, NY 11801, USA, prepaid. Liteway Inc. will then, at
its option repair or replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the
cost of the defective item only. No contingent liabilities of any kind
are either assumed or implied.
Any items returned to Liteway, Inc. that have been misused,
abused, damaged, modified, connected or adjusted in any way
contrary to the instructions furnished by Liteway, Inc. or repaired by
unauthorized personnel will not be covered by this warranty. Any
non-warranty repairs required will be quoted at the current rate for
such services.
Important Notices
CAUTION !
AVOID DIRECT EXPOSURE TO BEAM.
All –5, -7, -8, and -9 Models use laser diodes. These solid-state
laser diodes are located in the optical ports of these units. Laser
diodes produce invisible radiation that may be harmful to human
eyes. Never look directly into the optical port of any fiber optic unit
designed to operate with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications of
any kind.
© Copyright 2017 Liteway, Inc.
117061 Rev F
Operating Instructions
Fiber Optic
Video & Contact Switch
Data Transmission
System
VCT-1001 Transmitter
VCR-1001 Reciever
VCR-1002 Dual Reciever
The
Litelink
®
VCT/VCR-1001 system consists of the VCT-1001
transmitter and VCR-1001 receiver. Both transmits wide band video
signals and a contact closure over a single fiber.
Technical Specifications
Video Bandwith
8 MHz (+0, -3dB)
Video In/Out Impedance 75
ohms
Video In/Out Level
1 volt pp
Video Signal/Noise Ratio
60 dB typical
Output Contact Ratings
0.5 A @ 125 VAC (62.5VA)
1.0 A @ 24 VDC
Operating Wavelength
850nm (-1), 1300nm (-3,-7), 1550nm (-9)
Optical Output
-14dBm (multimode)
-10 dB (single-mode)
Optical Loss Budget
0 - 15 dB (multimode)
0 - 18 dB (single-mode)
Fibers Accommodated
1 multimode (-1,-3), 1 single-mode (-7,-9)
Temperature Range
-35º to +75ºC
Power Requirements
11-24 VAC/DC @150 mA
Physical Size (mm)
5.0”(127)L x 1.0” (25.4)W x 3.0”(7)D
All specifications measured with 1Km of 62.5u multimode fiber.
All specifications are subject to change without prior notice.
!
