WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it’s subsidiaries are fully tested prior
to shipment and are warranted against defective materials and
workmanship for a period of five full years from the date of the original
shipment. Should a problem occur, a Return Material Authorization
Number (RMA) must be obtained from Liteway Inc. at (516) 931-2800
and the item returned to Liteway, Inc. 166 Haverford Road, Hicksville,
NY 11801, USA, prepaid. Liteway Inc. will then, at its option repair or
replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the cost
of the defective item only. No contingent liabilities of any kind are either
assumed or implied.
Any items returned to Liteway, Inc. that have been misused, abused,
damaged, modified, connected or adjusted in any way contrary to the
instructions furnished by Liteway, Inc. or repaired by unauthorized
personnel will not be covered by this warranty. Any non-warranty
repairs required will be quoted at the current rate for such services.
Important Notices
CAUTION !
AVOID DIRECT EXPOSURE TO BEAM
.
All -7,-8, and -9 Models use laser diodes. These solid-state laser diodes
are located in the optical ports of these units. Laser diodes produce
invisible radiation that may be harmful to human eyes. Never look
directly into the optical port of any fiber optic unit designed to operate
with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications of any
kind.
© Copyright 2017 Liteway, Inc.
106117 Rev G
OPERATING INSTRUCTIONS
Fiber Optic Video & Audio
Transmission System
Model VAT-1001, VAR-1001
The VAT/VAR-1001 system consists of the VAT-1001 transmitter and
VAR-1001 receiver and will transmit high quality baseband video in
accordance with NTSC, PAL and SECAM specifications as well as
two line level audio channels over a single optical fiber.
Technical Specifications
Video Bandwidth
8 MHz
Video In / Out
1 volt peak to peak , 75 Ohms, BNC
In / Out Signal Level
1 volt peak to peak
Signal / Noise Ratio
60 dB/min
Differential Gain
3% max
Differential Phase
3º max
Audio Bandwidth
15 Khz
Audio In / Out
1V RMS, 600 Ohms, ( 5 Pin terminal block)
Optical Output
-16 dBm typical
Optical Loss Budget
0 – 13 dB
Operating Wavelength
850 (-1), 1300 (-3,-7), 1550 (-9)
Fibers Accommodated
1 multimode fiber, ST connector (-1,-3), or
1 single-mode fiber, FC/PC connector (-7,-9)
Temperature Range
-35º to +75ºC
Power Requirements
11-24 VAC/DC @150 mA (3 pin term. block)
Physical Size (mm)
5.0”(127)L x 1.0” (25.4)W x 3.0”(7)D
All specifications measured with 1Km of 62.5u multimode fiber.
All specifications are subject to change without prior notice.
!
