Lissmac ATS 450, Руководство по эксплуатации, Страница: 9 / 44

9/44
1.1. Principle of intended use
The manufacturer and supplier cannot accept any liability for incorrect or unintended use. The
machine must not be modified by anybody other than the manufacturer. Modifications in the form of
additions or conversions may only be completed with the written consent of the manufacturer.
The machine is designed and built to the state-of-the-art and the acknowledged safety regulations.
Nevertheless, its use may result in dangers of injury and death of the user or third parties or adverse
effects to the machine and other property.
The machine must only be used if it is in technically perfect condition and for its intended use, with an
awareness of safety and potential dangers and as set out in the operating manual. In particular, faults
which may adversely affect its safety must be rectified immediately.
Intended
use
The LISSMAC masonry saw is exclusively designed for the cutting of building blocks made of mineral
material, using the wet curve cutting. It is prohibited to cut wood or metal! The masonry saw can only
be operated by one person and the use is limited by the position according to the intended use on the
rear part of the stone saw. The cutting table must be removed for transport.
Any other use beyond this is considered improper use.
Intended use also includes compliance with the operating manual and compliance with the inspection
and maintenance manual.
Unintended use
Foreseeable incorrect / unintended use:
•
Cutting without or with open blade guard
•
Cutting without water
•
Cutting wood, plastic or metal
•
Design modifications which alter the machine's safety or design type.
•
This masonry saw is only safe if it is used with LISSMAC saw blades.
1.2. Organisational action
This operating manual must be kept within easy reach for everybody at the place of use.
Supplements to the operating manual include general statutory and other binding regulations for
preventing accidents and protecting the environment and must be obeyed.
These duties may also relate, for example, to handling hazardous substances or wearing personal
protective equipment or road traffic regulations.
The personnel entrusted with the work must have read and understood the operating manual,
particularly the section entitled "Safety information" before starting work. It is too late to do so during
work. This particularly applies to personnel who only work on the machine occasionally, for example
setting and maintenance personnel.
Check at least occasionally that the procedures used by the personnel are safe and show an
awareness of the dangers and that they are following the instructions in the operating manual.