LiquoSystems iFerm Nano Terminal, Руководство по эксплуатации

Страница: 6 / 64

6
iFerm Nano Terminal
Safety notices
6
Position information
All stated positions (left, right, front, back, top, bottom etc.) relate to an observer looking at the
display of iFerm Nano Terminal from the front. The connecting cable is therefore at the bottom,
the display in front.
Special functions
These instructions describe both the basic functions and optional extensions of the
iFerm Nano Terminal . The special functions not included in the basic configuration are identified in
the instructions by asterisks ( * ).
If you wish to add one or more of these functions to your iFerm Nano Terminal , please contact our
customer service, see
“10.5 Customer service” on page 59
.
2 Safety notices
● Read the operating instructions carefully and obey all safety notices. Material damage resulting
from ignoring the safety notices is not covered by any warranty.
● Whenever you use iFerm Nano Terminal , follow the laws that apply at the place of use, particu -
larly the general safety and accident prevention regulations. If in doubt, these take precedence
over the directions in the operating instructions.
● iFerm Nano Terminal is operated with 230 V AC, 50/60 Hz alternating voltage. The power supply
must be properly connected and then checked and approved by a qualified electrician. There is
a risk of electric shock if the connection is faulty!
● Extreme temperatures caused by heat build-ups, frost, UV light, direct sunlight etc. can cause
irreparable damage. Always maintain the specified ambient temperatures, see
“10.1 Technical
data” on page 55
.
● iFerm Nano Terminal is protected against water jets (IP65). However, avoid intensive contact
with liquids (e.g. high-pressure cleaners).
● Lay cables so that they do not present a trip hazard and away from sharp-edged objects. Ensure
sufficient strain relief and kink protection.
● Clean the iFerm Nano Terminal with a soft damp cloth. Do not use any aggressive, scouring
cleaning agents or cleaning agents containing solvents.
● Do not perform any repairs on iFerm Nano Terminal . Follow the instructions in the chapter
“9 Maintenance and care” on page 54 .