Dive Computer
User Manual
Liquivision Products, Inc
-
37
-
Revision 1.9 Software 1.17
●
At the surface, display brightness will be at the setting chosen in the “Brightness” menu
●
Once you reach your Auto Dim depth, and below, the brightness will switch to Low
●
Between these two, the brightness will decrease linearly with depth (e.g., at half of the Auto
Dim depth, it will be halfway between the surface brightness setting, and Low)
If you set your Brightness setting to “Low”, the Auto Dim feature will have no effect.
The default Auto Dim setting is “Off”. You can adjust it in 10m / 30ft increments.
Your KAON display refreshes every fraction of a second – this allows it to update the information on
the screen. You can either set refresh rate to “Normal” or “Fast”. The default setting is “Normal”. In
most cases, you will not notice the screen flicker/refresh when set to “Normal”, but if you do, you can
set it to “Fast”. Using the “Fast” setting will shorten the battery life.
6.3. Refresh
In Rec and Tec Modes your KAON comes with a two underwater display layouts “Standard” and
“Graphic”. When diving within the no decompression limit, both displays are identical. However, when
you incur deco, the “Standard” display provides your deco information verbally “Stop” and “For”,
while the “Graphic” display uses the hand and clock icons.
6.4. Layout
Diving within NDL Limit
STANDARD – in DECO
GRAPHIC – in DECO
In Gauge Mode your KAON comes with four underwater display layouts to choose from:
STANDARD
SIMPLE
ALTERNATE
LARGE
