Dive Computer
User Manual
Liquivision Products, Inc
-
29
-
Revision 1.9 Software 1.17
Here you can setup the maximum PO2 for your Dive Gas. This will define how deep your Dive Gas
will still be considered breathable. The default (and maximum) value is 1.40. You can set it to any
value between 1.0-1.40 bar, in 0.05 increments.
4.2.2. PO2 dive
Here you configure the maximum PO2 for your Deco Gas. This will define how deep your Deco Gas
will still be considered breathable. The default (and maximum) value is 1.60. You can set it to any
value between 1.0-1.6 bar, in 0.05 increments.
4.2.3. PO2 deco
Here you can set up the depth of your last decompression stop. The default value is 3m / 10 ft, but you
can also set it to 6m / 20ft, so you won’t be affected as much by wave action during your last stop.
Please note this will only affect the depth of you last decompression stop if you incur decompression
during your dive. This will NOT affect the depth of the safety stop in a No Decompression dive (3
minutes at 5m / 15 ft)
4.2.4. Last deco stop
Here you can configure your one gas in Rec Mode, and up to three gases in Tec Mode.
4.3. Gases (only in Rec & Tec Modes)
Rec Mode
The default gas in Rec Mode is “Air”:
To modify it, tap Left and the cursor will highlight the gas:
Then tap Up to increase the oxygen % to your desired value. The gas will
switch from “Air” to 22%, then 23% and so on with each upward tap. The
maximum value is 40%.
