Liquid Controls LectroCount LCR 600, Инсталляционные компоненты

Страница: 24 / 78

Installation
LectroCount Ground Strap Kit
All seat cushions are grounded in a similar manner. The illustrations below detail the following instructions
for grounding three typical types of truck seats.
ESD Precaution
Install the LectroCount Ground Strap Kit before installing the LectroCount register.
Follow these steps to ground a truck seat:
1. Identify any adjustable, shock absorbing seat in the truck cab. These seats will
typically have pivot points, hinges, or other mechanical design features that make
seat adjustments possible.
Grounded Passenger Seats
Some truck seats, typically passenger seats, are not adjustable and do not require
grounding.
2. Find an existing screw or hole near the back of the seat frame, close to the cab
floor. If a hole or screw does not already exist, drill a 9/32” hole in the seat frame.
3. Attach one end of the ground strap to the seat frame bracket using the lock
washer, flat washer and nut provided.
Ensure a Good Ground
Remove any dirt or oxidation from the ground strap contact point. Lock washers should
penetrate any paint to ensure a good electrical connection.
4. Find an existing screw or hole, or drill a 9/32” hole, in the part of the seat frame—
above all pivots and adjustments—that is attached directly to the seat cushion.
Make sure that there are no intervening pivot points, guides, adjustment
mechanisms, etc., which could interfere with the ground path between the seat
cushion and the ground strap.
·
If the seat cushion has a wooden base, use a wood screw and washer to
attach the strap lug to the bottom of the seat at a point where the seat fabric