Rev: 08.18.21
Page 24
CCD-0004099
Extended Patio Position to Ramp Position
If the Lippert 3000 series ramp door is in the extended patio position and the ramp door is desired, use the
following procedure.
• Do not operate the ramp door on uneven ground.
• Always lower ramp door onto level ground.
• Do not lower ramp door into a ditch or gully.
• Do not release the ramp door until it rests completely on the ground.
• Do not stand behind the ramp door while operating.
• Keep all body parts clear of the ramp door while closing.
• Failure to heed WARNING may result in serious bodily injury or component and/or property damage.
NOTE:
Although the product is water resistant, LCI recommends storing the door in the closed position
during periods of rain to reduce the risk of water intrusion, which may result in delamination.
Moving parts can pinch, crush or cut. Keep clear and use caution.
1.
If applicable, remove the gap panels. Slide the rubber bulb side of the gap panel (Fig. 58A) off the
extrusion edge of the door jamb (Fig. 58B).
2.
Unsnap the three buckles (Fig. 59A) on the other side of the gap panel located around the rear side
panel vertical post (Fig. 59B). Store gap panels in a secure location.
A
Fig. 58
A
Fig. 59
3.
Located on the middle front gate panel or the driver's side front panel for the no-gate option, unlatch the
U-shaped latch (Fig. 60A) by flipping the latch over towards the driver's side front patio railing (Fig. 61A).
Fig. 60
Fig. 61
A
B
A
A
A
B
