3
574-537-8900
Rev: 09.17.20
Solera
®
Slide Topper
Access Kit
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002640
Prior to Installation
The unit will be equipped with a removable, cosmetic
access plate cover
(Fig.4A)
on the access plate
(Fig.4B)
.
This cover snaps on and off and must be removed prior to
installation of the access bracket.
Parts List
NOTE:
Part numbers are shown for identification purposes
only. Not all parts are available for individual sale. All parts
with a link to the Lippert Store can be purchased.
Solera Slide Topper Access Kit
For units with the Solera Slide Topper Access Plate
already attached.
Solera Slide Topper Access Kit - White
Solera Slide Topper Access Kit - White
Letter
Letter
PN
PN
Description
Description
Qty
Qty
A
768008 Access Bracket
2
B
768005 *Access Plate
2
C
786718 Set Screw, 1/4” - 20 x 1/2”
4
D
793617 *Screw, #10 - 13 x 1 1/4”
10
C
A
Solera Slide Topper Access Kit - Black
Solera Slide Topper Access Kit - Black
Letter
Letter
PN
PN
Description
Description
Qty
Qty
A
768007 Access Bracket
2
B
768004 *Access Plate
2
C
786718 Set Screw, 1/4” - 20 x 1/2”
4
D
793616 *Screw, #10 - 13 x 1 1/4”
10
B
D
Fig.4
Installation
All screws supporting the awning assembly
MUST
have a
backer within the structure of the wall of the unit. Refer to
unit manufacturer for proper location.
Installing the Awning Rail
Awning rail included.
1.
Position the awning rail along the line where the roof and
wall meet or a minimum of 3” above the upper edge of the
slide room the Solera
®
Slide Topper will cover. The awning
rail must be level and parallel with the top of slide room box
of the unit.
NOTE:
If mounting the Solera Slide Topper access plate
on the T-molding, see
(Fig.2)
, the awning rail must be a
minimum of 4
1/2
” above the upper edge of the slide room
the awning will cover.
2.
After determining the awning rail’s proper location, mark
its position with a non-permanent method of marking.
3.
Apply sealant along the horizontal length of the back
(Fig.5A)
of the awning rail.
4.
Align the awning rail on the wall and secure with
#8 - 18 x 1” screws, using all fastener holes.
* If the Access Plate is already installed on the unit these
parts will not be needed for this installation.
A
Fig.5
B
A
