Lippert Components Bed Lift, Руководство по сборке и эксплуатации

Страница: 14 / 24

Rev: 11.19.20
Page 14
CCD-0002764
8. Install the belt mounting brackets at the marked locations from step 7, onto wall of the unit with nine
#10 x 1" screws.
9.
Place the bottom side of the bed frame down on level supporting saw horses at the approximate fully
extended position. Make sure the bed frame is level.
10.
Extend one belt up from the bed frame, making sure the belt is not twisted and there is no slack
in the belt.
11.
Wrap the belt (Fig. 23C) over the top of the first belt plate (Fig. 23B). The belt extending up from
the bed frame should be in between the belt mounting bracket and the belt plate.
12.
Place the belt plate and the belt onto the posts (Fig. 23A) of the belt mounting bracket.
13.
Slide the second belt plate (Fig. 24A) onto the posts (Fig. 24B) of the belt mounting plate,
against the belt.
14.
Install the four previously removed M6 - 1.0 mm hex flange nuts (Fig. 25A) onto the belt mounting
bracket posts. Tighten the nuts to 10 ft-lbs.
15.
Place a belt mounting bracket cover (Fig. 26A) over the top of the belt mounting bracket (Fig. 26B).
16.
Repeat steps 10-15 for the other three belts.
Fig. 23
Fig. 24
Fig. 25
Fig. 26
A
B
C
A
B
A
A
B