4
574-537-8900
Rev: 06.08.20
Hotspot
™
OEM Prepped
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002226
5.
Position the external cellular antenna
(Fig.4B)
in place of
the external prep plate, on top of the gasket, inside the rim
of the external cellular prep plate
(Fig.4C)
.
Fig.5
6.
Using the pre-drilled holes in the external cellular
antenna
(Fig.4B)
, re-install the twelve previously removed
screws
(Fig.4A)
from step 3.
7.
Figure 5 depicts the completed installation of the
external cellular antenna.
Fig.6
B
C
A
Prepped Unit - Permanent Installation
1.
Locate the OneControl Hotspot prep plate
(Fig.6)
pre-installed in the unit.
2.
Attach one end of the two right angle coax cables
(Fig.1D)
into the two middle coax cable ports
(Fig.6A)
located
on the OneControl Hotspot prep plate.
3.
Place the cellular gateway on a level surface within 12”
of the OneControl Hotspot prep plate.
NOTE:
Before securing the OneControl Hotspot gateway
to a permanent location, make sure that you have located
your activation/claim code information card that has
the pertinent information to activate your OneControl
Hotspot Gateway. Place this card in a secured and easily
accessible location after activation. If the activation card is
lost a copy is located underneath the OneControl Hotspot
gateway.
4.
If desired, secure the cellular gateway
(Fig.7)
to a
permanent mounting surface by installing four
#8 x
3/4
” stainless steel pan head screws through the
provided holes in the cellular gateway
(Fig.7A)
and into a
permanent mounting surface.
5.
Attach the opposite end of the right angle coax cables
into the two corresponding ports marked 3G/4G of the
cellular gateway
(Fig.7B)
.
A
A
Fig.4
B
