Rev: 08.24.21
Page 5
CCD-0004349
With Plastic Collar
1.
Unscrew the black plastic collar from the faucet base and slide off from the faucet assembly.
Note:
Wiggle the plastic collar off the supply lines one line at a time.
2.
Slide the clear plastic washer off the faucet assembly.
3.
Place the faucet supply lines through the mounting hole on the deck, making sure the black rubber
washer and faucet base are seated firmly on the deck of the sink (Fig. 6A).
4.
Under the sink, slide the clear plastic washer over the supply lines up to the underside of the sink deck
and covering the mounting hole (Fig. 7A).
Fig. 6
Fig. 7
A
5.
Slide the black plastic collar back onto the supply lines, inserting one supply line at a time.
Note:
Make sure the inside threads of the black plastic collar are at the top.
6.
Screw the black plastic collar all the way up the faucet base until it will no longer turn (Fig.8A).
A
Note:
The red marked supply line is for hot water and the blue marked supply line is for the cold water.
7.
Thread the nut on the hot water supply line onto the hot water outlet supply valve and tighten with an
adjustable wrench. Do not over tighten.
8.
Thread the nut on the cold water supply line onto the cold water outlet supply valve and tighten with
an adjustable wrench. Do not over tighten.
9.
Turn the hot and cold water outlet supply valves back on and check for any leaks.
Be sure to keep dirt and debris from entering the water supply lines as this could cause irregular
water flow.
A
Fig. 8
Содержание Flow Max
Страница 1: ...Flow Max Faucets OEM INSTALLATION MANUAL...
