Lipco GSG-S-VM, Перевод оригинальной инструкции

Страница: 11 / 72

Instructions
Saddle-mount unit GSG-S-VM
11 - 72 010710-03-EN BA GSG-S-VM / 13.07.2020
7. Accident prevention
Failure to comply with the simplest basic rules are causing most ac-
cidents occurring during use, maintenance or transport.
Therefore, it is important that all persons involved with use of the
machine are aware of and comply with the following rules:
•
In order to achieve maximum performance from the GSG-S-VM
it must be in proper working condition. Perform maintenance and
repair only by trained people.
•
Replacement parts must fulfill the minimum technical specifica-
tions required by the manufacturer! Only use of
LIPCO original
replacement parts will fulfill these requirements.
•
Before each use, check the trailer hitch bolts on the three-point
mount and all studs and nuts!
•
Exercise special Note when using roads or paths, e.g. for turning
the entire tunnel spray unit.
•
Always shut off the motor and remove the ignition key when per-
forming maintenance or repairs!
•
During work and transport on public road, do not transport ob-
jects or persons on the machine!
•
Operate machine only with drive unit fully protected, i.e. univer-
sal joint shaft completely covered and additional protection on
tractor and
GSG-S-VM. Make sure that the universal joint shaft
connections lock securely into place!
•
The machine should be on a level surface or a stable support
during all work on the machine!
When working on the machine in raised position, always secure
by mechanical means using suitable supports!