LinMot C1250 Series, Руководство по установке

Страница: 13 / 32

Installation Guide C1250
NTI AG / LinMot 0185-1063-E_6V16_IG_Drives_C1250 Page 13 of 32
8.6
X17 – X18
X17 – X18 RealTime Ethernet 10/100 Mbit/s
X17 RT ETH In
X18 RT ETH Out
Specification depends on RT Bus. Please refer to according documentation.
RJ-45
8.7
X19
X19 System
1
2
3
4
5
6
7
8
case
(Do not connect)
(Do not connect)
RS232 Rx
GND
GND
RS232 Tx
(Do not connect)
(Do not connect)
Shield
RJ-45 Use isolated USB-RS232 converter (Art.-No. 0150-2473) for configuration over RS232
8.8
X33
X33 Safety Relays (only with the -1S option)
4 / 8
3 / 7
2 / 6
1 / 5 Ksr +
Ksr -
Ksr f+
Ksr f- Safety Relay 1 / 2 Input positive
Safety Relay 1 / 2 Input negative
Safety Relay 1 / 2 feedback positive
Safety Relay 1 / 2 feedback negative
Spring cage connector (has
to be ordered separately:
see chapter 15)
- Use 60/75°C copper conductors only
- Conductor cross-section max. 1.5mm
2
- Stripping length: 10mm
- The state of the feedback contacts has to be checked after each change of the state of the control
contacts!
- Never connect the safety relays to the logic supply of the drive!
→ For detailed information see chapter 10 Safety Wiring.
8.9
S1 – S2
S1 – S2 Address Selectors
S1 (5..8)
S2 (1..4)
Bus ID High (0 … F). Bit 5 is the LSB, bit 8 the MSB.
Bus ID Low (0 … F). Bit 1 is the LSB, bit 4 the MSB.
Setting the ID high & low to 0xFF resets the drive to manufacturer settings!
The use of these switches depends on the type of fieldbus which is used. Please see the corresponding manual for
further information.