LinMot 0150-4370, Руководство по установке

Страница: 37 / 47

Installation Guide Linear Motors ENG
NTI AG / LinMot P01-48-HP EX protected Page 37 / 47
6.2 Cleaning in assembled state
•
Attention: Strong magnetic attraction forces! (note section «Warning signs») Use non magnetic material
(e.g. wood) to cover close-by iron constructions.
•
Position the slider at the top and clean the visible slider area with a soft disposable paper, ideally with
the aid of LU06 cleaning spray (alternatively methylated spirits or alcohol).
•
Move the slider down and clean the visible slider area with a soft disposable paper, ideally with the aid of
LU06 cleaning spray (alternatively methylated spirits or alcohol).
6.3 Cleaning in disassembled state
•
Pull the sliders carefully out of the stator.
Attention: Strong magnetic attraction forces! (note section «Warning signs») Use non magnetic material
(e.g. wood) to cover close-by iron constructions.
•
Clean slider and stator with a soft disposable paper, ideally with the help of LU06 cleaning spray (or
methylated spirits or alcohol).
•
Finally, slider should be inserted according to the chapter «Mounting the motor».
6.4 Cleaning agent
For the cleaning of LinMot stators and sliders cleaning agent spray LU06 is recommended.
Ordering information
Item Description Item-No.
LU06-250 Klüberfood NH1 4-002 Spray* (250 ml) 0150-2394
* LinMot Spray LU06 corresponds to KLÜBERFOOD NH1 4-002 which was developed for the food
processing industry.
6.5 Stator checking
The following tables show the resistive value between the different connector pins for each stator type. If the
value is not within a range of +/- 10% the stator may be damaged (temperature of the stator for all
measurements: 20°C).
PS01-48x150G-HP-EX-E (Art: 0150-4370)
PS01-48x150G-HP-EX-E-FC (Art: 0150-4371)
/ Phase1- Red / Pink Pin A / Pin B
0.8

/ Phase2- Blue / Grey Pin C / Pin D
0.8

5V / GND White / Inner shield Pin 1 / Pin 2
155

Sensor Sine / GND Yellow / Inner shield Pin 3 / Pin 2
33 k

Sensor Cosine / GND Green / Inner shield Pin 4 / Pin 2
33 k

Temp. Sensor / GND Black / Inner shield Pin 5 / Pin 2
10 k

Phase / GND - Pin 1 - 4 / Pin 2
> 20 M

All Pin / Shield - Pin A - 10 / Housing
> 20 M

Pt1000 1 - Pin 7, 8
1080

@ 20 °C
Pt1000 2 - Pin 9, 10
1080

@ 20 °C