Linmore LED Labs
| 2360 S Orange Ave, Fresno CA 93725 | 559-485-6010 | www.linmoreled.com | [email protected]
Site Lighter (SL1) Installation Instructions | Page 1 of 4
SITE LIGHTER (SL1) INSTALLATION INSTRUCTIONS
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
These instructions do not purport to cover all details or variations in components nor to provide for every possible
contingency to be met in connection with installation, operation, or maintenance. Should further information be desired
or should a particular problem arise which is not covered sufficiently for the purchaser’s purpose, the matter should be
referred to Linmore LED Labs. Linmore does not claim liability for any installation not performed according to this guide or
not by a qualified electrician.
When using electrical equipment, basic safety precautions should always be followed including the following:
1.
DANGER – RISK OF SHOCK – DISCONNECT POWER BEFORE INSTALLATION
2.
WARNING
– Risk of fire or electric shock. LED Upgrade Kit installation requires knowledge of luminaires electrical systems. If
not qualified, do not attempt installation. Product must be installed in accordance with NEC or your local electrical code. If
you are not familiar with these codes and requirements, contact a qualified electrician.
3.
WARNING
– Risk of fire or electric shock. Luminaire wiring and electrical parts may be damaged when drilling for
installation of the LED upgrade kit. Check for enclosed wiring and components.
4.
WARNING
– Risk of fire or electric shock. Check the existing wiring for damage before installing upgrade kit. Do not install
if existing wires are damaged.
5.
WARNING
– To prevent wiring damage or abrasion, do not expose wires to the edge of sheet metal or any other sharp
objects.
6.
WARNING
– Risk of fire or electric shock. Install this kit only in the luminaires that have the construction features and
dimensions shown in the photographs and/or drawings.
7. The retrofit assembly is accepted as a component of a luminaire where the suitability of the combination shall be
determined by UL or authorities having jurisdiction.
8. Only the holes indicated in the photographs or drawings may be made or altered as a result of the kit installation. Do not
leave any other holes open in a wiring enclosure or electrical component.
Revised January 31, 2019 12:26 PM
