Linksys WCGP200, Руководство пользователя, Страница: 15 / 31

Chapter 2: Installation
Installing the Battery
This section provides information on installing batteries into the EMTA. Follow the steps below:
1. Ensure the power cord is unplugged.
2. Remove the battery cover on the rear panel. There are two battery compartments. You may install a
single battery into either compartment.
3. Insert the battery into one of the rear battery compartments, as shown below.
4. Reattach the battery cover.
5. Plug the power cord into an AC-recepticle that is always ON (non-switchable). It’s best to secure the plug to the
wall plate using an extended wall plate screw. The battery will fully charge within 4 hours.
5