Link4 iPonic 614, Инструкция по установке и эксплуатации

Страница: 15 / 52

960-3100-00
iPonic 614 Installation Manual 9
TIP: Settings Shortcuts
Throughout this section you will be shown how to adjust basic settings
through the menu, however, you can also change the basic settings of
your selected equipment from the home screen by pressing the
numbered button corresponding to the equipment output and then by
using the wheel to select Settings. In any numbered menu, the number
buttons can also be used to jump to that number selection without using
the wheel.
Light Control
Lighting Equipment Setup
If you wish to control the lights in your facility with the iPonic TM 614 make sure the equipment is selected
using the Equipment Selection procedure at the beginning of this chapter. Your light output is Output 1.
Because lights generally require a stronger current than the controller can handle you will want to plug
your light ballasts into a trigger box which will be powered by another source. Then you will plug the
trigger cable from the trigger box into outlet 1 of the iPonic
TM 614 controller. If you would like to control
more than one bank of lights see the Advanced Settings section of this manual.
Changing Light Settings
You can adjust the time
your lights are powered
on by adjusting the
Day/Night Setpoints as
discussed in the previous
section. You can also
adjust this same time
setpoint through “Light
Setting”. From the home
screen of your iPonic
TM
614, press the menu
button. Select option 1,
“Current Setpoints” and press OK. Select option 4, “Light Setting” with the wheel and press OK. To adjust
the start time of your Day time setpoint press button 5 on the user interface. Use the buttons and wheel
on the user interface to set the start time for your Day time setpoint. Press OK when you have selected
the correct time. Press OK again to save your changes. To adjust the end time of your Day time setpoint
(the beginning of your Night time setpoint) press button 6 from the Light Setting screen and adjust this
time in the same way.
CO
2
Control
CO
2
Injector Setup
If you wish to control the CO
2
level in your facility with the iPonic TM 614 make sure the equipment is
selected using the Equipment Selection procedure at the beginning of this chapter. When saving this
setting for the first time you will be prompted to choose whether you will be using a CO
2
tank or a CO
2
generator. A CO
2
tank will run according to a default on/off cycle which can be altered through advanced
programming options. A generator will run whenever the CO
2
measured in the growing environment falls
below the target. Assuming a small (less than one ampere) CO
2
valve for your CO
2
output, this equipment
type can be plugged directly into outlet 2 of the iPonic TM 614 controller.
Changing CO
2
Target Settings
From the home screen of your iPonic TM 614, press the menu button. Select option 1, “Current Setpoints”
and press OK. Select option 3, “CO2 Setpoint” with the wheel and press OK. To adjust your CO
2
daytime
target press button 5. You can use the wheel to change the CO
2
target by an increment of 1 ppm or you
can press button 1 to change this increment to 10 ppm or 100 ppm and then use the wheel to change the
CO
2
target by the selected increment. When you have set the desired CO
2
target press OK. When you
are satisfied with all of your CO
2
settings press OK. Press OK one more time to save your changes.
Temperature Control
Heater Setup
If you wish to control a heater with the iPonic TM 614 make sure the equipment is selected using the
Equipment Selection procedure at the beginning of this chapter. Because a heater will generally require a
stronger current than the controller can handle you will want to plug your heater into a trigger box which