LineEye LE-650H2, Инструкция по установке и эксплуатации

Страница: 19 / 44

17
＜
Mark and meaning
＞
Mark Meaning
Indicates that there was a CRC error.
Indicates a transaction which contains a PRE (preamble).
Indicates SSPRIT (start SPLIT).
Indicates CSPLIT (Complete SPRIT).
unknown
If there is a packet ID (PID) that is not defined in the USB 2.0 standard,
Displayed when the packet ID is normal but the packet length is unreasonably short (or long)
5-2. Detailed display of request / descriptor by class
If there is a transaction which begins from the "SETUP" packet as shown in a figure, a "request
type" and the mark will be displayed on the right side.
Device request details window" like the right opens when mark is clicked with the mouse, and
information on request Descriptor is displayed in the shape of the tree.
<Types of device requests supported>
・
Standard device request
・
HUB Class-Specific device request
・
HID Class-Specific device request
・
Audio Class-Specific device request
・
Communication Class-Specific device request
・
MassStorage/Bulk Only Transport-Specific device request
・
Printer Class-Specific device request
・
USBTMC Class-Specific device request
・
Video Class-Specific device request
・
Wireless controller Class-Specific device request
*only for HCI protocol for Bluetooth dongle
<Types of descriptors supported>
・
Standard descriptor
・
HUB Class-Specific descriptor
・
HID Class-Specific descriptor
・
Audio Class-Specific descriptor
・
Communication Class-Specific descriptor
・
Video Class-Specific descriptor
* The USB protocol analyzer software searches the
log data for GET_DESCRIPTOR requests in order
to identify the class / subclass to which the target
device request belongs. Therefore, if the GET_
DESCRIPTOR request related to the Configuration
descriptor does not exist in the same log data, it
may be displayed as "Undefind" because the class to
which it belongs cannot be identified. In this case,
specify the class in "Device Class Setting". However,
device classes which the USB protocol analyzer
LE-650H2 / LE-650H2-A does not support will be
displayed as "Undefind".
* By clicking the arrow on the upper right of the request
details display window, you can display the previous
and next device request details. You can adjust the
density of the device request details window by
sliding the knob on the slide bar on the right side.