LineEye LE-2500XR, Инструкция по эксплуатации

Страница: 55 / 140

-53-
ڦ
RTS on
Time between the start of data trans-
mission and RS becomes “ON.”
ڦ
TXD transmit
Time between CTS becomes “ON”
and the start of data transmission.
ڦ
RTS off
Time between the end of data trans-
mission and RTS becomes “OFF.”
ڦ
DTR on
4.3 Auto Line Control
ON/OFF of control lines and timing of data transmission can be controlled automatically according to the setting of
interface mode (DTE/DCE) for simulation.
“ON” means active, and “OFF” means non-active.
〇
DTE mode
Set the timing of following item in the range between 0 and 9999
ms.
〇
DCE mode
Set the timing of following item in the range between 0 and 9999
ms.
Press [MENU] and touch “Interface ” and set “Mode” to “DTE” or
“DCE”. Mark on “Auto line control” and touch “Setting”.
For standard sub-board, this setting is available only for RS-
232C port.
Example of above program
Execution of the above program
DTR is always “ON” during test.
ڦ
CTS on
Time between RTS becomes “ON”
and TXD becomes “ON”.
ڦ
CTS off
Time between RTS becomes “OFF”
and TXD becomes “OFF”.
ڦ
DCD on
Time between the start of data trans-
mission and DCD becomes “ON.”
ڦ
RXD transmit:
Time between DCD becomes “ON”
and the start of data transmission.
ڦ
DCD off
Time between DCD becomes “OFF”
and end of data transmission.