LineEye LE-2500XR, Инструкция по эксплуатации

Страница: 51 / 140

-49-
Data Editing Method
ڦ
Copy, cut and paste
Touch “ ” -> “ Selection”or press [ENTER]. Then, “copy”
and “cut” will be appeared on the bottom of screen. Selected
data on the cursor is marked on blue.
As the cursor is moved with characters selected, they will be
marked on blue.
Touch “copy” or press [END/X] to copy the data, or touch
“cut” or press [TOP/DEL] to cut the data on the clip board.
Move the cursor to the place needed to be pasted, and then
touch “paste” or press [END/X].
The number of selected byte are displayed on the top of screen.
Data selection ends after pressing [ESC] or touching another data.
Copied or cut data on the clip board will be eased after turning off the power.
ڦ
Delete table
Touch “ ” -> “Clear table” to delete a table. Touch “Execute” or press [ENTER]. To cancel this operation,
touch “Cancel” or press [ESC].
ڦ
Fill in data
Touch “ ” -> “Fill data” and specify the begin data, end
data and filling size. Touch “Execute” or press [ENTER].
Begin data< End data : A character from “Begin data” toward “End data” will be inputted increasing
one by one till the number of size set in “Fill size” is filled.
Begin data> End data : A character from “Begin data” toward “End data” will be inputted decreasing
one by one till the number of size set in “Fill size” is filled.
Begin data= End data : The data is entered into the table for the specified size.
On the right figure, “01h, 02h, 03h, 01h, 02h, 03h, 01h, 02h” will be inserted in the table.
Input “Begin data” and “End data” by [0] ~[F] in HEX.
If there is not enough remains, it will fill the data partway.