background image

3

10. TRANSMITTER INSTALLATION OPTIONS

12. INSTALLING MULTIPLE TRANSMITTERS

9. APPLY POWER - SELECT DIALING METHOD

11. INSTALLING SINGLE TRANSMITTERS

218266 C     IMAGE 5

WHEN IT IS INSTALLED
WITH THE JUMPER SET
FOR INSTANT

IT WILL

FUNCTION

AS ACTIVITY

FOR DXS-31 STATIONARY TRANSMITTERS

WHEN IT IS INSTALLED
WITH THE JUMPER SET
FOR DELAY

IT WILL

FUNCTION

AS EMERGENCY

WHEN IT IS
INSTALLED
WITH THE
RIGHT BUTTON

IT WILL ONLY
ACTIVATE
USING BOTH
BUTTONS

FOR ALL TWO-BUTTON TX'S EXCEPT

 

DXS-63

WHEN IT IS
INSTALLED
WITH THE
LEFT BUTTON

IT WILL
ACTIVATE
USING
EITHER
BUTTON

FOR MODEL DXS-32: CUT JUMPER (INSTANT TX) FOR USE

AS AN ACTIVITY TX. SEE DXS-32 INSTALLATION INSTRUCTIONS

ADDS MULTIPLE TRANSMITTERS

PRESS TEST BUTTON
• 4 BEEPS SOUND
  (TEST MODE)

3

2

ACTIVATE TRANSMITTER
• 1 BEEP SOUNDS
  (TX ADDED)

REPEAT STEPS 2 & 3 FOR
ADDITIONAL TRANSMITTERS
(UP TO 16 TOTAL)

1

PRESS TEST BUTTON AGAIN
• 5 BEEPS SOUND
  (ADD TX MODE)

4

NOTE: IF THE CONSOLE'S MEMORY
IS FULL, ONE LONG BEEP SOUNDS
WHEN TRYING TO ADD A TRANSMITTER 

PRESS CLEAR TO RETURN TO OPERATE MODE
• 2 BEEPS SOUND WITH ACTIVITY TIMER ENABLED
• 3 BEEPS SOUND WITH ACTIVITY TIMER DISABLED

THE CONSOLE WILL RETURN TO OPERATE
MODE AUTOMATICALLY AFTER 3 MINUTES

5

DXS-21

DXS-63

NOTE: EACH TIME THE TEST BUTTON IS PRESSED IN THE ADD TX MODE,
THE CONSOLE WILL BE READY TO INSTALL A TRANSMITTER IN THE NEXT
AVAILABLE SENSOR ZONE LOCATION. IF THE VB-4 VOICE BOARD IS
INSTALLED, THE CONSOLE WILL ANNOUNCE THE SENSOR ZONE LOCATION
NUMBER.

TURN POWER
SWITCH ON

ON

IF REQUIRED, CHANGE THE DIALING METHOD
BY PRESSING AND HOLDING THE HOME & CLEAR
BUTTONS WHILE SWITCHING THE POWER ON

• 7 BEEPS SOUND FOR PULSE DIALING
• 8 BEEPS SOUND FOR TONE DIALING

NOTE: THE DEFAULT DIALING METHOD IS TONE DIALING

ADDS ONE TRANSMITTER AT A TIME

PRESS CLEAR BUTTON
FOR 5 SECONDS
• 5 BEEPS SOUND
  (TX ADD MODE)

1

2

ACTIVATE TRANSMITTER
• 1 BEEP SOUNDS
  (TX ADDED)
CONSOLE REVERTS
TO OPERATE MODE

NOTE: IF THE CONSOLE'S MEMORY
IS FULL, ONE LONG BEEP SOUNDS WHEN
TRYING TO ADD A TRANSMITTER 

3

REPEAT STEPS 1 & 2 FOR ADDITIONAL
TRANSMITTERS (UP TO 16 TOTAL)

NOTE: PRESS CLEAR BEFORE TRANSMITTING TO RETURN
TO OPERATE MODE WITHOUT ENTERING A TRANSMITTER
• 2 BEEPS SOUND WITH ACTIVITY TIMER ENABLED
• 3 BEEPS SOUND WITH ACTIVITY TIMER DISABLED

THE CONSOLE WILL RETURN TO OPERATE MODE
AUTOMATICALLY AFTER 30 SECONDS

DXS-21

DXS-63

firealarmresources.com

Содержание PERS2400A









Отзывы: