XT Series HFC Repeater
Quick Start Guide
Page 1 of 2
Thank you for purchasing an XTENDR XT series HFC repeater from Lindsay Broadband.
Please ensure all contents received are correct and intact. If you did not receive the item(s) ordered, or if the contents are damaged, please contact Lindsay for
support. Do not return products to Lindsay without first obtaining an RMA number from Customer Service.
The full installation and operation manual can be found on Lindsay's website (https://www.lindsaybb.com) in the Resources Document Library, or on the XTENDR
product page under Documentation and Tools.
TECHNICAL SUPPORT
•
T: +1.705.742.1350
•
TF: 1.800.465.7046 (U.S. & Canada)
•
GENERAL GUIDELINES
•
Use appropriate brackets to mount the XT device as per your needs.
•
Use the #5 Allen key tool included in the box to open/close the lid.
•
The length of the stinger center conductor used with XT series HFC repeater is 0.9” (23.0 mm). A to-scale guide for cutting the stinger length
is provided below. Please use this guide for all stingers on the XT series HFC repeater.
CUSTOMER SERVICE
•
T: +1.705.742.1350
•
TF: 1.800.465.7046 (U.S. & Canada)
•
•
The device can be powered in two ways using 40-90 VAC HFC power:
1.
To Power from the Dedicated Powering Port:
Remove the bung/cap on the top right
corner of the unit. Remove the PSU lid. Slightly undo the top screw at the terminals. Insert
the stinger in the port. Secure the screw (see image below). The center conductor of the
stinger only needs to be secured in the top screw terminal of the PSU. The chassis serves
as the ground. When powering the device using this method (dedicated power port), make
sure to remove the power passing fuse from the device so that you do not damage the
equipment connected to the RF port.
2.
To Power from the RF Port:
Make sure that RF and power are combined on a single
cable. Make sure the fuse is installed.
