DTF – 1960 Series Operator Manual
13
WEEKLY CLEANING INSTRUCTIONS (CONT’D)
4. Clean unit cavity by brushing away any debris from the sides and bottom of the cavity. Wipe these
surfaces with a towel moistened with a non-caustic solution being careful not to get the heating elements
wet. DO NOT use water on heating elements. Allow the unit to dry for one hour before applying power.
5. After equipment has been cleaned and allowed to dry, reassemble in reverse order. Proper placement of
the finger assemblies is critical to the operation of the unit. Positioning pin must be aligned with the
“positioning pin grooves” in the finger assemblies (Figure A). Bottom fingers DO NOT have positioning pins
to align with and simply slide on finger track and stop at “finger track stop”.
FIGURE A
(Note: Illustration is shown with top cover of unit removed. This is for illustration purposes only! Operator
should never remove the top cover of the unit.)
Positioning Pin
Positioning Pin Groove
Finger Assembly
