Lincoln Electric Growth Series, Инструкция по сборке

Страница: 67 / 94

Assembly Guide
57
Step C8: Add the material support slats
Required parts /
components
Instructions
Illustration
The 2x4 water table provides a heavy-duty support system for the material being cut using slats that you
supply (and replace from time to time) from local material. Placed on edge, with a slight curvature, the slats de-
velop the strength required to provide durable, long lasting service. Sparks, debris, and smoke from the cutting
process are minimized because of the open access to the water surface between the slats.
Qty Part Description Part #
1 Assembled water table with pan From
Step C7
19 Material support slats
30
1
⁄
2
" x (3 to 4)" x
3
⁄
16
"
(Obtain slats
locally — not
supplied)
• Cut nineteen material support slats from
3
⁄
16
" thickness material. Make them 30
1
⁄
2
" long and
between 3" and 4" wide. (This material is not supplied with your water table.)
• 3" to 4" high slats may be used. A 4" high slat will place the material at the top of the
water table. A lower slat height allows greater control over water contact with the cut
material.
• Insert the slats into the slat support brackets in the pan. The offset in the brackets creates
a curve in the slats, which increases their strength and weight-bearing capacity.
• Over time, you will replace slats. This is normal.
The material to
be cut will rest
directly on the
slats