Lincoln Electric Growth Series, Инструкция по сборке

Страница: 52 / 94

Torchmate Growth Series
42
Once the VMD software is installed and configured, the table can be moved under software control. This step
positions the inner and outer side bearings using the motion of the gantry, and it checks for any movement
problems as adjusted at normal speeds.
Step B8: Jog gantry to set side bearings
Required parts /
components
Qty Part Description Part #
1
Motor Cables
Ethernet
Crossover
Cable
Laptop or PC, Accumove2, and wired
CNC Cutting table
From Steps B7
Instructions
• The nuts holding the inner and outer gantry side bearings should be loose enough to move
with a little pressure, but not so loose they "rattle." The gantry should still be at one end.
• At each rail, move the inner and outer bearings toward the rail so they just touch the rails.
• Open the VMD software and click the
Configuration button. Datum the table, and load the
correct configuration file. See Step B6 and B7.
• Click the Home button. Click the Job Setup button.
• Click the -Y and +Y arrow buttons to move the gantry from one end of the table to the
other. As the bearings have not been tightened, they will self-adjust during the movement.
• Use the jog Arrow buttons to move the gantry to the other end of the table. The arrows
are sensitive to their touched position. Touching and sliding toward the tip increases speed,
while touching and sliding toward the center of the arrows decreases speed.
• If there are any clearance issues with the side bearings, they will self-adjust.
• Without moving the side bearings from where they self-adjusted, tighten the inner and
outer side bearings at each end of the gantry.
TECHNICAL SUPPORT
Toll Free: 1-866-571-1066
International: 775-673-2200
Fax: 775-673-2206
Email: support@torchmate.com
If the gantry
binds, contact
Torchmate
Technical Support
Use the Y-axis arrow
keys to jog the gantry
to each end of the
table
Illustration