Lincoln Electric Growth Series, Инструкция по сборке

Страница: 48 / 94

Torchmate Growth Series
38
Step B4: Set the IP address
For security, the Accumove2 controller restricts its communication to only a computer with a known (static)
IP address running the Accumove2 software. The controller itself also uses a static address.
• The first time you use the Accumove2, its IP address is pre-set to 192.168.1.7 and it also
requires the computer to use 192.168.1.6. After installing the crossover cable, set the
computer’s address.
• From your computer's Control Panel, open the
Network and Sharing control panel. On
the left side, select Change Adapter Settings .
• In the Network Connections window, disable all connections except for the wired
crossover cable connection by right clicking on the icon(s) and selecting Disable .
• Right click on the crossover connection and select Properties . Select Internet protocol
version 4 (TCP/IPv4) . Select the Properties button below the list.
• Select Use the following IP address . Enter 192.168.1.6 in the IP address field. Press
the Tab key to fill in the Subnet mask. Click OK to save.
• Power on the Accumove2, then start the VMD software.
Qty Part Description Part #
1
Motor Cables
Ethernet
Crossover
Cable
Computer with VMD software and
Accumove2
From Step B3
Required parts /
components
Instructions
Installation
screens
Select Use the following IP address
Disable all connections except the
Accumove2. To check, unplug/replug
the red cable