Lincoln Electric Growth Series, Инструкция по сборке, Страница: 44 / 94

Torchmate Growth Series
34
Overview of wiring
For adjusting the 2x4 Growth Series CNC Cutting System table, you only need a minimal setup for the Torch-
mate Accumove2. Establish communications between the controller and the computer, load the software,
and run the X and Y motor cables from the table to the controller. Later, you will see how to connect a typical
plasma cutter and other tools.
Summary • The Accumove2 controller is the destination for the table's motor cables and the
computer's Ethernet crossover cable. The cable ends are ready to plug in to the back of the
box.
• The Accumove2 box should be located so that it is not exposed to cutting spatter (or
splashing from a water table), and so that the motor cables do not need to be coiled.
• Coiled cables can introduce troublesome noise into the electronic signals and should be
avoided.
Illustration of
initial wiring
needed for
table adjustment
Motor Cables
Ethernet
Crossover
Cable
Illustration of
wiring needed
later for typical
table operation