Subject index
1
1 – Start teaching....................................................43, 46
2
2 - Stop teaching.....................................................43, 46
A
Activate preset..................................................................36
C
Carattere non valido.......................................................56
Counts per revolution....................................................52
Counts/rev...........................................................................34
D
Device search.....................................................................31
Device type.........................................................................32
Disconnected cable.........................................................56
E
Enable analog output.....................................................37
Enable preset......................................................................37
Encoder HW counts.................................................48, 51
Encoder HW counts to be converted.......................56
Encoder travel not valid: counts to be displayed
greater than physical resolution between start
and stop...........................................................................36
Encoder travel not valid: unable to reach the
minimum stroke...........................................................36
Error creating the file.....................................................56
Error reading the file......................................................56
L
Load default parameters...............................................32
M
Max number of revolutions.........................................52
Max total counts..............................................................52
N
No error................................................................................37
O
Output range......................................................................38
Output type.................................................................32, 38
P
Port.........................................................................................31
Position.................................................................................34
Positive counting direction..........................................37
Preset.....................................................................................34
Programming mode: Prog (cyclic ramp)................50
Programming mode: Prog (single ramp)................47
Programming mode: Start / Stop (cyclic ramp)..44
Programming mode: Start / Stop (single ramp)..41
R
Read parameters...............................................................32
S
Serial number....................................................................32
T
Turns......................................................................................34
V
Value not valid: preset...................................................56
Version..................................................................................32
