EM58 PA
3.2.3 EMC60 PA installation using the antirotation pin and the fixing
plate
•
Remove the antirotation pin
1
(see the Figure on page 14);
•
fix the tempered pin
6
to the rear of the motor;
•
mount the encoder on the motor shaft using the reducing sleeve
8
(if
supplied). Avoid forcing the encoder shaft;
•
make sure the anti-rotation pin
6
is inserted properly into the fixing plate
7
;
•
fix the collar
3
to the encoder shaft.
A = min. 8, max. 18 mm
NOTE
You are strongly advised not to carry out any mechanical operations (drilling,
milling, etc.) on the encoder shaft. This could cause serious damages to the
internal parts and an immediate warranty loss. Please contact our technical
personnel for the complete availability of "custom made" shafts.
MAN EM58 PA E 1.1
Mechanical installation
16 of 60
