Lightwave Communications SCS1620, Руководство по эксплуатации продукта

Страница: 20 / 98

SCS1620 Product Manual Lightwave Communications
Page 20 www.lightwavecom.com
•
If you take longer than 30 seconds between entries, the SCS1620 will
time out and exit; any of your unsaved changes will be ignored.
5. To REVIEW the saved settings, simply press the UP or DOWN arrows to
step through the current settings.
4.2 Method #2 - Quick Start via Telnet
Assuming you have a functioning IP network, and you know your workstation's IP
address, you can access the SCS1620 via telnet commands. If you add a route
to your workstation, you can use telnet to connect to the SCS1620, instead of the
Terminal Port. The default IP address of the SCS1620 is 10.0.0.1, with a subnet
mask of 255.0.0.0.
•
For Windows 9x, from the DOS / command prompt, type:
route add 10.0.0.1 mask 255.0.0.0 <your workstation's IP address> route add 10.0.0.1 mask 255.0.0.0 <your workstation's IP address> route add 10.0.0.1 mask 255.0.0.0 <your workstation's IP address> route add 10.0.0.1 mask 255.0.0.0 <your workstation's IP address>
<enter>
<enter> <enter> <enter>
•
For Linux / Unix, type:
route add 10.0.0.1 gw <your workstation's IP address> <enter>
route add 10.0.0.1 gw <your workstation's IP address> <enter> route add 10.0.0.1 gw <your workstation's IP address> <enter>
route add 10.0.0.1 gw <your workstation's IP address> <enter>
Then, from your command line, type:
telnet 10.0.0.1 <enter> telnet 10.0.0.1 <enter> telnet 10.0.0.1 <enter> telnet 10.0.0.1 <enter>
to access the SCS1620.