6. Software Control - Lightware Device Controller
UCX series – User's Manual
51
Applied firmware package: v1.2.0b9 | LDC software: v2.5.10b1
6.6.
Port Properties Window
Clicking on the port tile opens the Port properties window. This section shows the available settings and
status information by port types.
#lock #unlock #mute #unmute
6.6.1.
Welcome Screen
Welcome screen is an internal source which can be customized by uploading an image file.
#welcomescreen
ATTENTION!
Video crosspoint has a limitation:I1 and I5 ports are not available at the same time, only one
of them can be selected to any output.
Busy
label on the crosspoint tile refers to the limitation.
General
Port name
The name of a port can be changed by typing the new name and clicking on the
Set
button. The following
characters are allowed when naming: Letters (A-Z) and (a-z), hyphen (-), underscore (_), numbers (0-9), and
dot (.). Max length: 63 characters.
Lock
#lock #unlock
The port can be locked to the currently connected output ports by putting the tick. If the port is locked, the
crosspoint state of this port cannot be changed.
Mute
#mute #unmute
The welcome can be muted/unmuted by putting a tick. If the port is muted, no signal is transmitted from
the input port.
Welcome Screen Settings
Display Welcome Screen Image
Put a tick to
Display Welcome Screen Image
to enable the appearance of the internal image.
Upload Image
Click to the
Upload Image
Button to browse jpg or bmp file to customize the welcome screen picture.
Recommended resolution: 1280x720 pixel, maximum file size is 4MB.
ATTENTION!
Uploading a new image will overwrite the previous one.
Reset Image
Clicking on reset image button restores the factory default state.
Display Welcome Screen Message
Put a tick to
Display Welcome Screen Message
to enable the appearance of the text message.
Welcome Screen Message
The following characters are allowed: Letters (A-Z) and (a-z), hyphen (-), underscore (_), numbers (0-9),
space ( ) and dot (.). Max length: 63 characters.
