Lightware UBEX-PRO20-HDMI-F100, Руководство пользователя, Страница: 78 / 185

6. Lightware Device Controller (LDC) series – Extender Application Mode – User's Manual 78 6. Lightware Device Controller (LDC) series – Extender Application Mode – User's Manual 78
EXTENDER APPLIC
A
TION MODE
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
6.5.9. Local HDMI Input Ports (RX Mode)
Clicking on the HDMI input 1 or 2 port icon results in opening the Port properties. The most important signal
and display information and settings are available on the panel: #hdcp
Port properties window of the HDMI in 1 (RX)
Available settings and tools:
▪ Port naming;
▪
HDCP setting
(Enable / Disable);
▪ Frame Detector ;
▪
Reloading factory default settings
for the selected port.
6.5.10. HDMI Output Ports (RX/TRX Modes)
Clicking on the HDMI output 1 or 2
port icon results opening the Port
properties. The most important signal
and display information and settings
are available on the panel: #hdcp
#power5v #timingmode #freerun
#sourcelocked
Available settings and tools:
▪ Port naming;
▪
HDCP mode
:
– Depends on input: the
level and version of HDCP-
encryption depends on the
source device;
– Maximum possible: the
output ports set the
maximum HDCP-encryption
level which can accept by
the connected sink device.
– Forced HDCP 2.2 Type 1: the
output ports always force
HDCP 2.2 Type 1. If the sink
device supports this HDCP-encryption level, the signal will be encrypted with HDCP 2.2 Type 0/1.
The signal will be encrypted with HDCP 2.2 Type 1 when the source and the sink either support this HDCP-
encryption level.
▪
Power 5V mode
(Auto / Always on / Always off);
▪
Timing mode
(Free run / Source locked).
ATTENTION! When the Source locked mode setting was unsuccessful and the port uses Free run mode
as fallback, an

icon appears beside the settings. It may causes that the scaler / FRC setting is not in
Pass-through mode or the resolution of the source stream is not the same that the destination stream's
one.
▪ Frame Detector ;
▪ Identify Stream / Identify Display button;
▪
Reloading factory default settings
for the selected port.

  

  