Lightware MX16x16DVI-Pro, Руководство пользователя

Страница: 17 / 79

MX32x32DVI-Pro
User’s Manual
Page 17 / 79
2 Operation
2.1 POWER
Connect the power cord to the router’s IEC standard power input connector.
MX32x32DVI-Pro is immediately powered ON when the power cord is connected to
the AC source. The router does not have a power switch, it remains powered on,
until AC line voltage is present.
After powered on, the unit performs a self test, then all front panel buttons light up
for one second. During self test the two digit Status Display indicates the test
phases. After the self test the router reloads its last configuration and it is ready to
use. In case of hardware failure a two digit error code is displayed.
Info At switching ON, the router reloads the latest settings which were used before it
was turning off. MX32x32DVI-Pro has an internal emergency memory which stores
all current settings, and ties configurations. This memory is independent from
presets and invisible for the user. This built-in feature helps the system to be ready
immediately in case of power failure or accidentally powering down.
2.2 FRONT PANEL OPERATIONS
2.2.1 TAKE / AUTOTAKE modes
The router has two different switching modes: TAKE and AUTOTAKE. If the TAKE
button is unlit, TAKE mode is active. When the TAKE button is continuously lighting
green, AUTOTAKE mode is selected.
Press and hold the TAKE button for two seconds to change between TAKE and
AUTOTAKE modes.
TAKE mode allows the user to make multiple connections and deselections at
once. This mode is useful when time delay is not allowed between multiple
switchings.
AUTOTAKE mode is useful when immediate actions must be done or fast
switching is needed between sources on a destination.
2.2.2 CONTROL LOCK
Front panel button operations can be enabled or disabled using CONTROL LOCK
button, while RS232/422 control is still enabled. If it unlits, front panel button
operations are enabled. If there is coninuously red lighting, front panel operations
are inhibited.
Press and release CONTROL LOCK button to toggle the control lock state.