Lightware MX16x16DVI-Pro, Руководство пользователя

Страница: 10 / 79

Page 10 / 79
1.3 Features

50 meter input cable compensation
– Using 22AWG high quality DVI cable, the
inputs are automatically compensated for up to 50 meter cable
length, which extends installation possibilities even on highest
HDTV or computer resolutions. In case of lower pixel
resolutions, this length can be even higher.

Advanced EDID Management
–
The user can emulate any EDID on the switcher's
inputs independently, read out and store any attached monitor's EDID
in 100 internal memory locations, upload and download EDID files
using Matrix Control Software.

Non-blocking cross point matrix architecture
– The router allows any input to
be switched to any output or more outputs simultaneously.

1.65 Gb/s channel transmission
– Routes any DVI single link signal between 25
and 165 MHz pixel clock frequency conforming to DVI 1.0
standard or dual link depending on input card type.

Supports all HDTV resolutions
– 720p, 1080i and 1080p etc. without HDCP
encoding - Unencrypted HDTV signals up to 165 MHz pixel
clock frequency regardless of resolution are passed through
MX32x32DVI-Pro

Signal Detect LED-s at each input connector
– Active DVI signals are detected:
clock channel activity is green indicated, when signal is applied
to the input.

Output PLL reclocking
– (removes jitter caused by long cables ) each output has
a clean, jitter free signal, eliminating signal instability and
distortion caused by long cables or connector reflections.

Front panel buttons control
– 32/16 source select, 32/16 destination select,
Take, Load preset, Save preset, Panel Lock, Output Lock

Relegendable buttons
– Each button has an easy removable flat cap and a
translucent label which can be inserted under it to identify
sources and destinations.

RS232 or RS422 control
– Simple ASCII based RS232 protocol is used for
switching, preset calling, status request, etc.

Ethernet control
– TCP/IP Ethernet 10Base-T or 100Base TX (Auto-Sensing)

Built in WEB site
– easy access from a WEB browser to control and configure the
switcher

Fiber cable support
– Self powered DVI fiber cables using +5V from DVI sources
( VGA cards, etc.) usually consume more than 50 mA, which
load is maximum allowed by DVI 1.0 standard. MX32x32DVI-
Pro su5V 500 mA constant current output on each DVI
output to power long distance fiber optical cables.

Universal power supply
– MX32x32DVI-Pro accepts AC voltages from 100 to 240
Volts with 50 or 60 Hz line frequency on standard IEC
connector.

Power failure memory
– In case of power failure the unit stores its latest
configuration, and after next power up it loads automatically.