7. Programmer’s Reference
MX-FR Series Modular Matrix Frames – User's Manual
140
Applied CPU2 firmware: v3.5.7b8 | LDC software: v2.5.17b2
7.11.2. Querying the Set RICOD MASTER
Checks the status of the previously set RICOD command for the selected input port.
Command and Response
ȩ
{:RICOD#
<in>
@
<S/A>
I=?}
Ȩ
(RICOD#
<in>
@SI=
<A1><A2>
;
<B>
;
<C>
;)CrLf
Parameters
See the previous section.
Example
ȩ
{:ricod#1@si=?}
Ȩ
(RICOD#1@SI=11;1;1;)CrLf
RICOD command was enabled on the first input port, which locks the remote device and selects the first
video and audio input port on it.
7.11.3. Querying the RICOD SLAVE Status
Checks the previously set RICOD status for the selected output port of the local device.
Command and Response
ȩ
{:RICOD_SLEN#
<out>
@
<S/A>
O=?}
Ȩ
(RICOD_SLEN#
<out>
@SO=
<num>
)CrLf
Parameters
Identifier
Parameter Description
Parameter Values
<
out
>
Output port number
Output number in 1 or 2 digit ASCII format (01, 3, 04 etc.)
<
S/A
>
Affected ports
S
= single selected input
A
= all inputs
<
num
>
RICOD enable
parameter on the
output
1
: The RICOD functionality is enabled on the given output port. If a
RICOD command is detected it will be executed.(If it is possible.)
0
: The RICOD functionality is disabled on the given output port. Any
incoming RICOD command will be rejected.
Example
ȩ
{:ricod_slen#1@SO=?}
Ȩ
(RICOD_SLEN#1@SO=1)CrLf
RICOD functionality is enabled on the first output port on the local device.
7.11.4.
Setting the RICOD SLAVE Status
Enables or disables the reception of RICOD commands over the selected output port of the local device.
Command and Response
ȩ
{:RICOD_SLEN#
<out>
@
<S/A>
O=
<num>
}
Ȩ
(RICOD_SLEN#
<out>
@SO=
<num>
)CrLf
Parameters
See previous section.
Example
ȩ
{:ricod_slen#1@SO=1}
Ȩ
(RICOD_SLEN#1@SO=1)CrLf
RICOD functionality is enabled on the first output port on the local device.
