5. Device Concept
MMX8x4-HT series – User's Manual
40
Applied firmware package: v1.2.2b5 | LDC software: v2.2.1
5.3.4.
The Autoselect Feature
The autoselect mode can be set on output ports for each input with Lightware Device (LDC) Controller
software (see more info about it in
HDMI and TPS Output Port Properties
section) or with the LW3 protocol
(see more info about it in
INFO: An input port is active if there is a valid signal on it.
There are three types of Autoselect as follows:
First detect mode:
Selected input port is kept connected to the output while it has an active signal.
Priority detect mode:
Always the highest priority active input is selected to transmit.
The proper priority setting requires fulfill the conditions below:
▪
Match the priority to the input ports. 0 means the highest, 7 means the lowest priority. If two inputs
have the same priority number, the lower port number gets higher priority.
▪
Certain inputs can ignore by clicking the green tick or write
31
instead of the priority number. This port
will be not scanned. See more details about this setting in
section.
▪
Always confirm the settings by clicking on
Set priorities
button.
Last detect mode:
Always the last attached input is selected to transmit.
See the Flowchart of Autoselect Modes in the Appendix chapter.
INFO: Autoselect mode is always disabled on locked output. If the crosspoint is changed manually, the
autoselect function became also disabled.
