5. Software Control – Lightware Device Controller
MMX6x2-HT series – User's Manual
34
5.7.
Preset Settings
The matrix has six user-programmable presets. Each preset stores a configuration regarding the crosspoint
and mute state for all inputs/outputs. All presets are stored in a non-volatile memory; the router keeps
presets even in the case of power down. The presets can be run from the front panel or by sending protocol
commands, too.
Preset settings
Loading a Preset
Step 1.
Select the
Presets
tab from the
Crosspoint
menu.
Step 2.
Select the desired preset; check the
Preview
panel and press the
Load
button. Press
Yes
in the
confirmation window.
INFO: Presets which were saved by the front panel buttons previously are listed with names Preset1..
Preset6 as default. See the corresponding
section.
Load
Saving a Preset
Step 1.
Arrange the desired crosspoint connections.
Step 2.
Select the Presets tab from the Crosspoint menu and choose a target preset slot from Preset 1..
Preset 6. Type the desired Preset name in the indicated text field up to 16 characters. The followings
are allowed when naming: letters (A-Z and a-z), hyphen (-)underscore (_), and numbers (0-9).
Confirm it with
Rename Preset
button.
Step 3.
Press the
Save
button and
Yes
to confirm for storing the configuration.
Renaming a Preset
Step 1.
Select the desired preset you want to rename.
Step 2.
Type the desired name and press the
Rename Preset
button.
Deleting a Preset
Step 1.
Select the desired preset you want to delete.
Step 2.
Press the
Clear
button and
Yes
to confirm
Auto Load Mode
When the
Auto Load
button is highlighted with green, the mode is active. In this case, confirmation is not
required: the selected preset is loaded immediately when the button is pressed.
Save
Rename preset
Clear
Auto Load