Lightware HDMI-TPS-RX220AK, Руководство пользователя, Страница: 35 / 118

5. Software Control - Lightware Device Controller HDMI-TPS-RX220AK – User's Manual 35
Applied firmware package: v1.4.0 | LDC software: v2.4.0b3
5.5.4. Audio - TPS In 1 and HDMI In 2
These are the audio input signals of
the receiver. Clicking on the port icon
results opening the settings panel
appearing in a pop-up window. You
can check the status of the line, signal
and display info.
Available Settings and Information:
▪ Port name: a unique name can
be set for the port.
▪
Mute/Unmute
port;
▪
Lock/Unlock
the port;
▪ Embedded audio information;
▪ Reloading Factory Default
Settings .
5.5.5. Audio - HDMI out 1 and 2
These are the HDMI audio output
signals of the receiver. Clicking on the
port icon results opening the settings
panel appearing in a pop-up window.
You can check the status of the line,
signal and display info.
Available Settings and Information:
▪ Port name: a unique name can
be set for the port.
▪
Mute/Unmute
port;
▪
Lock/Unlock
the port;
▪ Autoselect Feature ;
▪ Embedded audio information;
▪ Reloading Factory Default
Settings .
5.5.6. Audio - Analog Audio Out
This is the audio input signals of the
receiver. Clicking on the port icon
results opening the settings panel
appearing in a pop-up window. You
can check the status of the line, signal
and display info.
Available Settings and Information:
▪ Port name: a unique name can
be set for the port.
▪
Mute/Unmute
port;
▪
Lock/Unlock
the port;
▪
Volume
: the volume of the audio
signal can be adjusted from 100
to 0%, in step 1% (0 dB to -57
dB, in step 0.375 dB (default is
0 dB));
▪
Balance
: the balance of the left
and right channel of the signal
can be adjusted from -100 to
100, in step 1 (default is 0 =
center);
▪ Autoselect Feature ; #analogaudio #volume #balance
▪ Embedded audio information;
▪ Reloading Factory Default Settings .
5.5.7. Autoselect Feature
Clicking on the Autoselect
Configure
button on one the output
port properties window results opening the Autoselect feature
configurator. Pay attention for the following settings for the
proper operation of Autoselect function: #autoselect
▪ Set the Autoselect settings to be
enabled
for the desired
input ports;
▪ Set the desired
Operation mode
(see more details about it
in The Autoselect Feature section);
▪ Set the
priority number
in case of Priority detect operation
mode.
▪ Always click on the
Apply
button after the changes to
launch the new settings.
   