ATTENTION!
The cloning is successful when the backup file is downloaded from the same type of source
device as the destination device. E.g. HDMI-3D-OPT-TX210A contains fewer ports than
SW4-OPT-TX240RAK. If the backup file is downloaded from the TX240RAK and uploaded
to an TX210A transmitter, that would result in errors when checking and uploading.
The restoring process
Step 1.
Select the
Settings
/
Backup
tab from the menu.
Step 2.
Click on the
Choose file
button on the right panel and
browse
the desired file.
Step 3.
The file is checked and the result will be displayed in the textbox below. If the file is
correct, the settings can be restored.
Step 4.
Press the
Start restore process
button and click on the
Yes
button when asked.
Step 5.
Reboot the device to apply the network settings after finishing.
6.9.4. Network settings (only for SW4-OPT-TX240RAK)
The backup file contains some lines with the network settings:
132
SET /MANAGEMENT/NETWORK.DhcpEnabled=false
133
SET /MANAGEMENT/NETWORK.StaticIpAddress=192.168.0.100
134
SET /MANAGEMENT/NETWORK.StaticNetworkMask=255.255.255.0
135
SET /MANAGEMENT/NETWORK.StaticGatewayAddress=192.168.0.1
136
CALL /MANAGEMENT/NETWORK:ApplySettings()
Above example shows that line
no. 132
contains that the DHCP is disabled and line
no.
133
contains the static
IP address of the appliance. If the file is uploaded to one or more
devices, the exact same settings will be applied. To avoid a possible IP address conflict on
the network, follow one of these steps:
Option 1 – Applying dynamic IP address in all the devices
▪
Before the backup process: Make sure that the DHCP is enabled on the device, or
▪ After the backup process: Modify the backup file in a text editor (e.g. Notepad) and
search the following line:
SET /MANAGEMENT/NETWORK.DhcpEnabled=false
Replace the
false
value to
true
.
ATTENTION!
The static IP address will be uploaded to the device if the line is in the backup file but will
be ignored when DHCP is enabled.
INFO
The factory default IP address of the LW3 devices is static.
Option 2 – Applying static IP addresses
Be aware that if the backup file is uploaded (restored) in multiple devices, it will cause
an IP address conflict. In this case, you have to change the IP address in the backup file
manually before uploading it to each device; search this line:
SET /MANAGEMENT/NETWORK.StaticIpAddress=192.168.0.80
Set the desired IP address and save the file.
Option 3 – Keep the original IP settings
If the Network settings of the destination device shall stay unchanged, make sure
that these lines are deleted from the backup file, before you upload and restore it in a
device. The network settings are listed at the end of the file (the lines starting with
SET /MANAGEMENT/NETWORK and CALL /MANAGEMENT/NETWORK
).
HDMI-3D-OPT-TX200 series
User’s manual
Software control
Page 47 / 106
Содержание HDMI-3D-OPT-TX210A
Страница 1: ...HDMI 3D OPT TX210A HDMI 3D OPT TX210RAK SW4 OPT TX240RAK User s manual ...
Страница 2: ......