Lightware HDMI-3D-OPT-TX210A, Руководство пользователя, Страница: 23 / 106

The concept
If a video signal of the Blu-ray player is present on the HDMI input of the transmitter, the
source will be automatically switched to the optical output. If the video signal of the PC is
also present on the DVI-D input of the transmitter, it will be switched to the optical output. If
the Laptop is connected, the DP input will be switched to the optical output – independently
of the presence of the other video signals.
Settings
▪
Optical output
: Set the Autoselect to
Enabled
. The Autoselect mode is Priority detect.
The priorities are the followings:
Laptop:
0
(I1, DP IN)
PC:
1 (I4, DVI-D IN)
Blu-ray:
2 (I2/I3, HDMI IN)
The other inputs can be disabled. See settings in section 6.4.4 on page 34 .
4.3. Controlling features
The interfaces of the HDMI-3D-OPT-TX200 series transmitter can be used to install the
device at various point of a complex A/V system. Besides, the transmitter is able to handle
controlling functions. This chapter is about to present the possibilities through two simple
layout examples.
System control via local Ethernet (example)
The following ways are available for controlling the devices:
▪ The
System controller
can communicate with the
Transmitter
by LW2/ LW3 protocol
commands sent to the local IP:port address; see settings in section 11.6 on page
104 .
▪ The System controller can communicate directly with the Projector or an Extender via
their IP:port address.
▪ The
System controller
can communicate directly with the RS-232
relay box
connected
to the
Transmitter
. In this case,
Command Injection
mode has to be enabled on the local
RS-232 port.
▪ The
Transmitter
can send a command (e.g. as an action by the Event Manager) to the
IP:port address of the
Projector
or an
Extender
by using LW3 protocol methods; see
settings in section 8.8.9 on page 83 .
System control via local RS-232 (example)
The following ways are available for controlling the devices:
▪ The System controller can communicate with LW2/LW3 protocol commands via the
local RS-232 port of the Transmitter ; see settings in section 11.6 on page 104 .
System controller
LAN OPT OUT RS-232
SW4-OPT-TX240RAK OPT receiver Projector
Ethernet
LAN
Relay box
RS-232
System controller
RS-232 OPT OUT RS-232
OPT receiver HDTV SW4-OPT-TX240RAK
HDMI-3D-OPT-TX200 series
User’s manual
Optical extender concept Page 23 / 106