Lightware HDMI-3D-OPT-RX150RA, Руководство пользователя

Страница: 44 / 97

6. LW2 Programmer's Reference HDMI-3D-OPT series – User's Manual 44
6.2.3. View Firmware Version of the CPU
Description : View the CPU firmware revision.
Format Example
Command {f}
Response (FW:<FW_VER><s>)CrLf

{f}

(FW:1.1.0b5 r8)
Legend : <FW_VER> is the firmware version. It is followed by <s> string which may indicate special versions.
6.2.4. Connection Test
Description : Simple test to see if the connection is established successfully.
Format Example
Command {PING}
Response (PONG!)CrLf

{ping}

(PONG!)
6.2.5. View Serial Number
Description : The device responds its 8-digit serial number.
Format Example
Command {s}
Response (SN:<SERIAL_N>)CrLf

{s}

(SN:5A003192)
6.2.6. Compile Time
Description : Returns the date, when the microcontroller firmware was compiled.
Format Example
Command {CT}
Response (Complied: <DATE&TIME>)CrLf

{ct}

(Compiled: Jul 13 2017 11:17:56)
6.2.7. View Installed Board
Description : Shows the hardware name and revision of the installed card.
Format Example
Command {is}
Response (SL# ● 0 ● <MB_DESC>)CrLf
(SL ● END)CrLf

{is}

(SL# 0 SW4-OPT-TX240RAK V11_DAA0)

(SL END)
Explanation : The device reports its motherboard (slot 0).
6.2.8. View Firmware for All Controllers
Description : Shows the firmware versions of all installed controllers.
Format Example
Command {FC}
Response (CF
●
<DESC>)CrLf
(CF
●
<DESC>)CrLf
…
(CF END)CrLf

{fc}

(CF SW4-OPT-TX240RAK 1.1.0b5 r8)

(SL END)
Explanation : The device has one control panel.
6.2.9. Restart the Device
Description : The device can be restarted without unplugging power.
Format Example
Command {RST}
Response

{rst}
Explanation : The device reboots; no response is sent in this case.
6.2.10. Query Health Status
Description: Internal voltages and measured temperature values are shown.
Format Example
Command {ST}
Response (ST
●
<DESC>)CrLf

{st}

(ST CPU 1.29V 1.89V 3.25V 3.30V 4.99V 47.44C
47.43C)
6.2.11. Restore Factory Default Settings
Description : Settings can be reset to factory default values as follows:
Format Example
Command {FACTORY=ALL}
Response (FACTORY ALL…)CrLf

{factory=all}

(FACTORY ALL…)
Explanation : All settings and parameters are reset to factory default, see the table in the Factory Default
Settings section.
  
