3. Product Overview
HDMI-TPS-RX110AY series – User's Manual
18
Appliedfirmwarepackage:v1.5.0b3 | LDCsoftware:v2.5.9b2
3.2.
Rear View
1
DC 12V IN
Localpowerin;connecttheoutputofthesupplied12VDCpoweradaptor.
For more details see next section.
2
TPS IN (PoE)
Locking RJ45 connector. Connect a twisted pair cable between the
transmitter and the receiver. Remote powering is also available through this
connector. Maximum CATx cable distances can be found in the
section.
3
SIGNAL status LED
TheLEDgivesimmediatefeedbackaboutcurrentstateoftheHDMIoutput
signal. See the legend below.
4
HDMI OUT
Connect an HDMI cable between the receiver and the local sink device.
Applied cable shall not be more, than 30 m (when the signal is 1080p) and
20m(whenthesignalis4K).
5
HDCP status LED
TheLEDgivesimmediatefeedbackaboutcurrentstateofHDCP.Seethe
legend next to the table.
6
AUDIO OUT
5-pole Phoenix connector for asymmetric analog audio output. Pin
assignment can be found in the next section.
2
4
6
3
5
1
Front/Rear LEDs
TPS Input LED (Remote power, left)
off
Remote power (PoE) is inactive, device is powered locally.
amber
on
Remote power is active.
TPS Input LED (TPS connection, right)
off
No TPS link between the transmitter and receiver.
green
blinking
Device is in low power mode or Ethernet fallback mode.
green
on
TPS signal is present.
SIGNAL LED for HDMI Output
off
Output signal is not present or muted.
green
on
Signal is present.
HDCP LED for HDMI Output
off
Output signal is not HDCP-encrypted.
green
blinking
Non-HDCP capable device is connected, encrypted signal is replaced with
red screen.
green
on
Output signal is HDCP-encrypted.